TinyPumpHouseCo. — DIY Pump House Kit
Protect your well pump, pressure tank, and equipment from Florida's heat, rain, and hurricane season — and build it yourself in under an hour.
Our DIY Pump House Kit ships directly to your door as 5 fully pre-built flat panels — 4 walls and 1 roof — with all hardware included. No cutting, no measuring lumber, no trips to the hardware store. Just set it up around your well and drive in 12 screws. That's it.
What's included:
-
4 pre-built wall panels (front with access door, back, and 2 side walls)
-
1 pre-built roof assembly (corrugated metal on wood frame)
-
8 timber lock screws (6") for connecting the walls — driver bit included
-
4 roofing screws for securing the roof
-
4 ground blocks to keep wood off the ground and protected from moisture
-
Full printed assembly manual with step-by-step diagrams
Tools you'll need: Drill, level, and tape measure — that's all.
Assembly overview: Place your ground blocks around the well, stand up the 4 walls, drive 8 screws into the pre-drilled corner holes, set the roof on top, and drive 4 screws up into the roof through the access door. Two people recommended. Most builds are complete in 30–60 minutes.
Built for Florida: Framed with 2x4 & 2x2 lumber, sheathed in 3/4" T1-11, trimmed with 1x6, and topped with a corrugated metal roof. Built to handle the heat, the rain, and the storms.
Need it installed for you? We offer full installation anywhere in Florida. Call or text us at (352) 263-9828 and we'll take care of everything.